#Gl inet openvpn client download serial
Note that soldering to the serial or I2C lands will require careful removal of the u.FL-like connectors for the antenna, as well as the heat sink on the back of the board. See, for example, (as the FCC website is unavailable at this time due to the shutdown).
Good internal photographs showing these clips are available in the FCC filing. Once the clips along the top have been released, the top will pivot upwards on the two clips on the front. The two clips on each side can be seen through the ventilation slots when the antennas are raised.
#Gl inet openvpn client download free
The three clips on the front and the two on each side can be gently worked free by inserting the blade of a putty knife in between the top and the bottom of the case. The top of the unit is integral with the front (with the LED holes/markings), It is retained with two clips on each side, three across the back, and two at the edge of the front, at the level of the PCB. Remove the two screws revealed by removal of the two feet. They are lightly adhered and should easily reveal two recessed screw heads. Remove the two gray “dot” feet at the back of the unit (nearest the Ethernet sockets). Putty “knife” (thin, flat blade, typically a little over 1” (25 mm) wide, not sharp, for spreading putty) See below for NAND support on ath79.Ĭertain public material may refer to this unit as GL-AR750S-Ext and/or GL.iNet Slate Supported on the legacy ar71xx and current ath79 platforms as of late 2018. Vendor specifications, including annotated board photos, are presently available at Significant changes include the use of GigE interfaces. Unit delivered in November, 2018 has the “advanced” screens (LuCI) showing Powered by LuCI openwrt-18.06 branch (git-18.196.56128-9112198) / OpenWrt 18.06.0-rc1 r7090-d2aa3a1b62Īnnounced in July, 2018, this is an “updated” version of the GL.iNet GL-AR750. Vendor advertises 17 Mbps for OpenVPN and 68 Mbps for WireGuard in August, 2018.ĭevice ships with “close to the tree” OpenWrt pre-installed with a set of packages and a GUI that are targeted at travel use, including repeater and VPN functions. It was professionally and attractively packaged. US-market unit delivered in November, 2018 included a very compact, Class VI, 5 V, 2000 mA adapter, USB-style power cable, and flat Ethernet cable. Vendor states 100mmX68mmX24mm, 86g (very roughly 4“x3”x1“).Īctual dimensions and weight are, including the antennas in the folded position, 103 mm x 68 mm x 24 mm, 110 g (The four soft “dot” feet take the thickness to ~25 mm). The unit has two external antennas that “fold” for compactness. Power is supplied through a micro-USB socket. Other notable features include a built-in microSD interface (vendor states support up to 128 GB), USB 2.0, and internal access to I2C, UART, and various GPIO. A small, lightweight “travel router”, it features dual-band operation and supports 802.11ac.
0 kommentar(er)
